I wanna be your slave amp settings — Fender Mustang LT25
The Maneskin guitar tone for “I wanna be your slave”, dialed in for a Fender Mustang LT25 with a Harley Benton ST-20HH ACTIVE SBK. Studio version, Teatro d'ira: Vol. I (2021) — main riff & choruses
Fender Custom Shop Stratocaster (bridge single-coil) into Marshall JCM800 2203 / Plexi stack pushed by an overdrive pedal
| Knob | Setting (0–10) |
|---|---|
| Gain | 6 |
| Bass | 4 |
| Mid | 7 |
| Treble | 7 |
| Master | 5 |
01OVERDRIVE
Onboard stomp block — acts as a clean boost to tighten low end and add cut
02SMALL ROOM
Onboard REV block — set subtly to replicate tight studio room ambience
Thomas Raggi records with a low-output vintage-style single-coil Strat into a biting Marshall stack, so your active humbuckers will push the front-end significantly hotter with extra low-end. The 80S ROCK model is tuned with bass dropped to 4 and mids/treble pushed to 7 to preserve cut and counteract humbucker darkness. Amp gain is kept at 6 while the onboard OVERDRIVE block is used with minimal drive and elevated level to deliver the sharp, percussive bite of the record. For the staccato verse riff, lightly palm-mute near the bridge saddles. Middle has no knob on the LT25: press the encoder to open the preset, press it again on the amp model, then select MIDDLE on the display and turn the encoder.
Get this tone on your amp
These settings are for a Fender Mustang LT25. ToneAdapt matches any song to whatever amp, guitar and pedals you own — first match is free.
Get ToneAdapt on Google PlaySong, artist and gear names are used to identify the tone being matched; ToneAdapt is not affiliated with or endorsed by the artists or manufacturers mentioned. Settings are AI-generated starting points — trust your ears.