Another Brick in the Wall pt.2 amp settings — Laney Lionheart foundry lf60-112
The Pink Floyd guitar tone for “Another Brick in the Wall pt.2”, dialed in for a Laney Lionheart foundry lf60-112 with a Dnd Lightfoot IB series. Studio version, The Wall (1979) — iconic guitar solo
1955 Gibson Les Paul Goldtop (P-90 pickups, neck pickup) straight into mixing console via DI and reamped through a Hiwatt DR103 / Mesa Boogie, compressed with studio optical compression and MXR digital delay
| Knob | Setting (0–10) |
|---|---|
| Gain | 4 |
| Bass | 6 |
| Mid | 7 |
| Treble | 5 |
| Reverb | 3 |
| Master | 6 |
01Compressor (MXR Dyna Comp style)
RECOMMENDED — not currently owned; essential for the squashed studio DI sustain
02Digital Delay
RECOMMENDED — not currently owned; set to roughly 440ms quarter-note echo
The LF60-112 is voiced around the British boutique Lionheart circuit, so Channel 2 dialed low gives the warm edge-of-breakup response Gilmour got from reamping the direct desk signal. Because your D&D Lightfoot has standard single coils rather than high-output vintage P-90s, keep the mids pushed to 7 and roll tone back slightly to round off top-end spank. For the rhythm funk comping during the verses, flip to Channel 1 clean and select the bridge+middle pickup position.
Get this tone on your amp
These settings are for a Laney Lionheart foundry lf60-112. ToneAdapt matches any song to whatever amp, guitar and pedals you own — first match is free.
Get ToneAdapt on Google PlaySong, artist and gear names are used to identify the tone being matched; ToneAdapt is not affiliated with or endorsed by the artists or manufacturers mentioned. Settings are AI-generated starting points — trust your ears.